Саркисян лотерея столото s8

10.3.2.1. Removal and installation of the engine

Before removal of the engine it is necessary to remove pressure a fuel supply system. For this purpose disconnect a block of a plait of wires of an electrogasoline pump from a plait of wires of system of injection, start the engine, let's it work to a stop, and then include a starter on 3 with for alignment of pressure in pipelines.
Disconnect a wire from the minus plug of the rechargeable battery.
Remove the air filter, having turned off fastening nuts to the unit of the central injection and to a hairpin on a cover of a head of cylinders, and having disconnected hoses from the filter. Disconnect wires from a nozzle and close a mouth of the unit of the central injection by a technological cap.
Disconnect hoses of a supply and discharge of fuel from tubes on the engine. Close openings of tubes and hoses that dirt did not get to them.
Disconnect a cable of the drive of a butterfly valve from the unit of the central injection and from an arm on an inlet pipe.
Disconnect from the unit of the central injection the vacuum hoses going to an adsorber and the sensor of absolute pressure and also a hose of system of ventilation of a case of the engine.
Disconnect wires from all devices of system of injection installed on the engine.
Further removal of the engine is carried out regularly.
Installation of the engine is carried out as it should be, the return to removal. After installation adjust the drive of an accelerator and check work of system of injection as it is specified in the Repair manual of system of the central injection of fuel.