8.4.3.1. Dismantling of a starter

Starter 35.3708. Turn off a nut on lower contact to a bolt of the traction relay and disconnect from it a conclusion of windings of the stator. Turn off nuts of fastening of the traction relay and remove it.

Fig. 8-17. Details of a starter 35.3708: 1 — a starter cover from the drive with an intermediate ring; 2 — a rubber cap; 3 — the drive lever; 4 — the traction relay; 5 — a cover from a collector; 6 — a brush; 7 — a brush spring; 8 — the protection cover; 9 — a lock washer; 10 — an adjusting washer; 11 — the case; 12 — a coupling bolt; 13 — an anchor; 14 — the isolating tube; 15 — the obgonny coupling with a drive gear wheel; 16 — a restrictive ring

Unscrew screws and remove the protection cover 8 (fig. 8-17). Remove a lock washer 9, turn out coupling bolts 12 and disconnect the case 11 with a cover 5 from a cover 1 with an anchor 13. Take out a cap 2 of a forward cover.
Unscrew fastening screws to brush holders of conclusions of a winding of the stator, and disconnect the case from a cover 5. Remove springs 7 and brushes 6.
Rasshplintuyte also take out from a cover a lever axis 3 drives of a starter. Take out the lever and an anchor with the drive from a cover, and then disconnect the lever from the drive.
To remove the drive from an anchor, remove a lock ring from under a restrictive ring 16. The drive understands after removal from a nave of the coupling of a lock washer.
If the traction relay is executed in folding execution, i.e. a detail of the relay not of a zavaltsovana in its case, then for its dismantling turn off nuts of coupling bolts and unsolder conclusions of windings from the plug "50" and from the tip fixed on lower contact to a bolt of the traction relay.
After dismantling blow details compressed air and wipe.
ST-221 starter. Features of its dismantling are connected with other design of a collector and a back cover.

Fig. 8-18. Details of a back part of a starter of ST-221: 1 — a stator pole; 2 — the seriyesny coil of a winding of the stator; 3 — the shuntovy coil of a winding of the stator; 4 — a rubber cap; 5 — a protective tape; 6 — a cover from a collector; 7 — the anchor shaft plug; 8 — a brush; 9 — a brush spring; 10 — a brake disk of a cover; 11 — the starter case

After removal of the traction relay weaken the screw of fastening of the coupling protective film 5 (fig. 8-18) on a cover 6 from a collector and shoot the film with laying. Turn out fastening screws to brush holders of plugs of brushes and conclusions of a winding of the stator, and remove brushes 8.
Turn off nuts of coupling hairpins and disconnect the case 11 with a cover 6 from a forward cover with an anchor. Turn out coupling hairpins from a forward cover and take out from it a rubber cap of the lever. Disconnect a cover 6 from the case.
Further dismantling of a starter of ST-221 is similar to dismantling of a starter 35.3708.