8.6.3. Replacement of lamps


Fig. 8-32. A view of a block headlight from a motor compartment: 1 — the screw of adjustment of a beam of light in the horizontal direction; 2 — a headlight casing; 3 — a plug block; 4 — the adjusting screw; 5 — the screw of adjustment of a beam of light in the vertical direction

Headlights. Turn a casing 2 (see fig. 8-32) counterclockwise and remove it. Remove from a reflector a lamp of a headlight and a cartridge with a lamp of dimensional light. To replace a lamp of the index of turn, take out from the headlight case a cartridge with a lamp.
Back lamps. Unscrew screws of fastening and remove a luggage carrier upholstery. Having wrung out clamps, take out from a lamp the printed circuit board assembled with lamps. Lamps are taken out from cartridges by easy pressing them and turn counterclockwise.
Lamps of illumination of registration plate. Lamps are located on a trunk lid. For replacement of a lamp unscrew screws of fastening of a lamp, take out it from a nest and remove the lens.
Plafond. For replacement of a lamp remove the lens of a plafond, having accurately hooked it the screw-driver from outside, opposite to the switch.
Side indexes of turn. For replacement of a lamp take out from a lamp a cartridge with a lamp from the inside of a wing.
Three-lever switch. The switch fastens a collar on a steering shaft arm.
Removal of the switch is carried out in the following order:
— remove a steering wheel;
— remove two half of a facing casing of a shaft of steering;
— remove a combination of devices and disconnect switch wires from a plait of wires of the car;
— remove the switch, having weakened a fastening collar.